Burda BPIR4 motion detector
protection: IP65 - dust-tight, protected against water jets from any direction
switching capacity: up to 4000 W
voltage: 230 V, 50/60 Hz
detection: PIR, up to 5 m, angle 100°
temperature sensor: set point 1 to 60 °C
on-time: 5 minutes, fixed
6 cm
10 cm
10 cm
0.28 kg
The Burda BPIR4 motion detector is an energy-saving motion detector with a temperature sensor for halogen infrared heaters. It switches the heater on only when people are present.
The built-in PIR sensor detects movement up to 5 m away in an angle of 100°. Each movement switches the heater on for 5 minutes and restarts the count. The temperature sensor keeps the heater off when it is warmer than the set point, which you set between 1 and 60 °C.
Soft start and zero-voltage switching cut the high inrush current of the lamps. According to Frico this can extend lamp life by up to 30 %.
The detector switches up to 4000 W. Frico lists it as an accessory for Burda Term IP67, Burda Term Short IP44 and Burda Term Multi IP67 (up to 2× 2000 W).
Mount the detector on a wall or ceiling. On a wall, place it 1 to 3 m high with the cable glands facing down. Do not point it at the heater lamps or place it near flues, air conditioners, moving bushes or reflective surfaces. It does not detect a person who is not moving. Have it connected by qualified personnel.
Technical data
| Frico code | BPIR4 (477355) |
| Control circuit consumption | 50 mA |
| Operating temperature | -20 to 40 °C |
| Terminals | 2.5 mm² |
| Cable glands | 2 |
Previously: MOTION DETECTOR for BH controller, IP65
Dimension drawing
